Zettex FR 300 is a high quality and durable single-part fire-resistant adhesive on a hybrid basis. This fire-resistant adhesive offers up to 4 hours of fire-resistance in linear joints. Zettex FR 300 also offers movement absorption to 25%. This hybrid adhesive can also be used in both horizontal and vertical joints and can be used for the fire-safe sealing of joints between wall, floor or ceiling. Applications for wooden and steel casings and all possible metal stud connections are then also provided with certification.
• 4 hours fire-resistance
• Useable in joints up to 30 mm wide.
• Little shrinkage.
• Suitable for wall/ceiling and wall/floor joints.
• Can be painted over with most water and oil based paints.
• Tested in conformity with EN 1366-4
• Certified for wood and steel casing joints.
• Certified for metal stud joints.
• Undesired air flows are prevented.
• Movement absorption to 25 %
• Resists moulds and vermin
• UV, weather and water resistant
• Not corrosive on metals
• Tube 290 ml
Suitable for the fire-resistant adhesion of connection and dilation joints in construction, that in the event of fire must have certain fire-resistance. The spread of fire, smoke or toxic vapours is counteracted. FR 300 is also certified for horizontal joints and connections to floor/ceiling with wall, wooden and steel casings and all stud applications. The fire-resistance is tested in conformity with EN 1366-4 to 240 minutes in a horizontal or vertical joint measuring 30 mm wide. Make sure of the correct fire-resistance for your applications by consulting the classification and test reports.
FR 300 is not suitable for PE, PP, PC, PMMA, PTFE, soft synthetics, neoprene and bituminous surfaces. The surfaces must be clean, dry and free of grease and dust. Neither may there be any old sealant residues on the surface. Although the FR 300 adheres excellently to most common surfaces it is recommended to first carry out a test. A primer may first be applied for optimal adhesion to some surfaces. Residues that have not properly hardened can be removed with Zettex Profireiniger. Smooth using Zettex Easyfinish within 10 minutes because of skin formation. FR 300 can also be painted over with most water and oil based paints. It is advised to test the tolerance of the paint beforehand. Hands can finally be cleaned with the Zettex Cleaning Wipes
|| Hybrid polymers
|| 1.36 g/ml
|Elongation at break
|Skin formation time
|| 30-60 minutes (at 23℃; 50 % R.H.)
|| +- 2-3 mm after 24 hours (at 23℃; 50 % R.H.)
|Temperature for use
|| Between 5℃ and 40 ℃
|| 35 Shore A
|| +- 25 %
|Modulus at 100 % stretch
|| 3.0 MPa.
|Skin formation at 23°C
|| 10 minutes
|| -40°C to +90°C
|Resistance to flow
|| 2 mm